Adjustable Power Supply Using LM317

                    I +-------+ O
  Vin (+) o-----+---| LM317 |---+--------------+-----o Vout (+)
                |   +-------+   |              |
                |       | A     /              |
                |       |       \ R1 = 240     |
                |       |       /              |           ___
               _|_ C1   |       |            +_|_ C2      |_0_|  LM317
               ___ .01  +-------+             ___ 1 uF    |   |  1 - Adjust
                |  uF   |                    - |          |___|  2 - Output
                |       \                      |           |||   3 - Input
                |       / R2                   |           123
                |       \                      |
                |       |                      |
  Vin(-) o------+-------+----------------------+-----o Vout (-)

For the LM317:

• R2 = (192 x Vout) - 240, where R2 in ohms, Vout is in volts and must be at between 1.2 V and 35 V.
• Vin should be at least 2.5V greater than Vout. Select a wall adapter with a voltage at least 2.5 V greater than your regulated output at full load
• Maximum output current is 1 A. Use proper heatsink for LM317 if it has to dissipate more than 1W.
• The tab of the LM317 is connected to the center pin.

Equation for calculating the output voltage when R1 and R2 are known:

 Vout = 1.25V * (1 + R2/R1) + Iadj * R2

Where Iadj is typically in the range of 50 microamperes.